I. Purpose: To test whether the sample continues to burn after withstanding the set temperature within the set time limit.
II. Operation.
1、 Place the instrument on the fixed platform.
2, turn on the power, the right rear of the instrument to switch the gate up to open the instrument.
3, set the upper limit temperature, press the red button, when you hear a beeping sound that the instrument is in working condition.
4, affected by the room temperature, heating takes a while. During the heating process of the instrument, put the sample to be tested on the test platform.
5 、When the instrument is heated to the set temperature automatically, the operator gently press the mechanical handle to make the steel rod touch the sample to be tested and test it within the specified time limit.
6 、Press the yellow button to turn off the instrument.
Note 1: Under the specified experimental conditions, generally 650 ℃ ± 10 ℃. Make the steel rod heated, touch the sample within 1S and stay on the sample surface for 5S.
Note 2: Repeat the above experiment for various samples of different materials to check whether the sample burns.
Contact Person: Ms. Ivy Xie
Tel: 86-13751491529
Fax: 86-769-38818154
ASTM E1354 HEAT RELEASE CONE CALORIMETER WITH OXYGEN ANALYZER
EN 11925-2 Building Material Flammability Tester with Touch Screen Control
Radiant Heat Flux Test Device For Paving Materials For All Kinds Of Flooring Materials
5T PC Controlled Tensile Strength Test Equipment 1200 * 530 * 1800mm With Software
Electronic Table Type Tensile Testing Machine Touch Screen Control
Lab Testing Equipment Computer Double Column Tensile Testing Machine
Automatic Oil Moisture Analyzer Coulometric Karl Fischer Titrator
Full Automatic Closed Cup Flash Point Tester
0-80kv transformer oil breakdown voltage tester Bdv Dielectric Strength Transformer Oil bdv Tester
Oil Analysis Testing Equipment Automatically Kinematic Viscosity Meter For Petroleum Product