PLC / HMI Table Slides Durability Furniture Testing Equipment with Servo Linear Actuator
What are the applications of Desk Drawer Slides Durability Testing Equipment?
This machine is suitable for testing the durability of the drawer slide mounted on the furniture. It can also set the force value to carry out the destructive test and measure the push-pull of the drawer.
This machine is suitable for testing the doors that are mounted on furniture for horizontal sliding, including the structure made of hinged joints door piece groups.
1. Durability test: Put a certain load inside the drawer, the drawer repeatedly pull and close the action, after a number of times, check the rails can also meet the use requirements.
2. Destructive testing: With a certain size of the force used in furniture parts, check under a certain load of furniture parts are damaged. Technical parameters
Complies with standard:
Test No. 10 Extendible Element Cycle Test;
Test No. 11 Extended Element Retention Impact & Durability Test;
Test No. 12 Extendible Element Rebound Test;
1.Accommodate up to a 12 (305mm) deep drawer
2.Accommodate “soft close” slides
3.Have the ability to adjust the stroke within 12 (3mm)
4.Have a minimum of 12 (305mm) of vertical adjustment
5.Can handle maximum load of 300 lb (135kg)
6.Speed rate between 0-.25 m/s.
7.Have a stroke counting device with failure notification and automatic stop with the number of successful completed cycles recorded
8.Have the ability to test a free standing application or application where the slides are already mounted in the application.
9.Designed for a minimum 15 million cycle life expectancy
|Slide size||10-24 (250-610mm) long|
|Drawer widths||10-24 (250-610mm) adjustable|
|Controller||PLC+ touch screen|
|Load cell capacity||200KG|
Contact Person: Ms. Ivy Xie